You start a mop run, the status light turns blue, the robot drives normally, and you may hear a faint high-frequency “buzz” from the VibraRise Module… but the mop pad stays dry and the floor shows zero wet trail. Sometimes the robot lifts the mop like it “thinks” it hit carpet, even on tile. That … Read more
Your Roomba does not “just get noisy.” It enters a repeatable control loop: you hear a sharp click-click-click (often rhythmic), the chassis may twitch, the robot may hesitate on turns, or it may click while docking. That sound usually equals one of two events inside the system: Mechanical skip: a gear tooth slips in the … Read more
Your Roomba doesn’t “just have hair on the rollers.” It enters a repeatable failure pattern: it starts, the Cleaning Head Module ramps up, you hear a sharp grinding or a strained whir, then the robot stops and throws Error 2 / “Clear the brushes”. On older units you may hear a two-tone “Uh-Oh” and beeps; … Read more
Your Shark doesn’t “just lose Wi-Fi.” It drops into a repeatable failure state: the Wi-Fi indicator stays red, the app shows Offline, and the robot either beeps once on the dock then goes quiet, or it starts pairing and hangs near the end like the credential handoff never commits. If you watch closely, you’ll often … Read more
Your Roborock drives confidently toward a stair edge… and doesn’t brake. The front drops, the drive wheels “whirr” as they lose traction, and you hear that sharp plastic-thud when it hits the lower step. Or you get the opposite glitch: it reaches a dark rug, chirps/announces an error, backs up, spins, and repeats the same … Read more
Your Roomba runs a mission, drives straight, and keeps suction normal—but the Edge-Sweeping Brush / Side Brush never rotates. You may hear a short click-click from the right-front underside, or a brief electric hum that stops after 1–2 seconds like the motor “gives up.” Corners stay dirty because the brush never pushes debris into the … Read more
You press CLEAN, the robot drives 10–30 cm, then enters a repeat loop: rotate-in-place → creep forward → rotate again. You may hear one Drive Wheel Module whine louder than the other, or you see the CLEAN light flash red after several spins. This is not “random.” Your Shark has entered a navigation recovery state … Read more
You dock the Roomba, it “clicks” into the Home Base / Clean Base, then the light ring turns red and you hear an error tone or a voice prompt that calls out Charging Error 5. Some units repeatedly re-dock like they’re stuck in a loop: drive up, back off, drive up again, fail again. // … Read more
